Magnum Energy ME-RC Manuel du propriétaire télécharger pdf (Page 82)

8.0 Using a BMK

• tAH Out (Total AHrs Removed) – This meter displays the total AHrs

removed from the battery since the Sense Module was ﬁ rst connected.

This display can be used as a battery service life indicator. The value

is displayed in 0.1k [or 100 AHrs (“k” equals 1000)] resolution up to a

maximum of 6,553.5k AHrs (6,553,500 AHrs). The displayed number

resets to 0.0k when the Sense Module is disconnected from power.

04 BM: Status – This menu selection offers read only displays that give the

current operating status of the battery monitor. This selection also provides

information to determine if there is a power-up fault condition.

• BM: Factory Fault – The BMK has lost its calibration setpoints that

were established at the factory.

• BM: No Comm – The battery monitor is not communicating with the

remote. This typically means a ME-BMK is not installed in the system.

If installed, view the Sense Module LED and refer to your BMK owner’s

manual

to help determine the issue.

• BM: Pwr-up Fault – The battery monitor faulted when it was powered-

up. The fault occurred because the power-up self-test failed. Refer to

your BMK owner’s manual.

• BM

: Ready – The battery monitor is connected and actively monitoring

the battery system.

05 BM: Setup – This menu allows the battery’s charging efﬁ ciency to be

automatically calculated or manually selected, and the battery’s amp-hours

to be set. Refer to Section 8.1 for more information on the Charge Efﬁ ciency

setting, and to Section 8.2 for the Batt AmpHr setting.

06 BM: TECH – These menu selections allow you to access the system

information used to assist service technicians in troubleshooting the battery

monitor or the charging system.

• BM Rev – This read only menu displays the ﬁ rmware revision level of

the connected battery monitor. If the battery monitor is not connected

or not communicating, the display will show “0.0”.

• Min DC – This menu displays the lowest battery voltage since the

last reset. The voltage shown on the display is averaged each second,

and is helpful when troubleshooting or detecting an over-discharge

condition.

To reset this display, press and hold the rotary SELECT knob for 5 seconds

while the Min DC display is shown. After this value has been reset, the

display will begin monitoring and showing new minimum DC input values.

If the battery monitor is not connected or not communicating, the display

will show “0.0”.

• Max DC – This menu displays the highest battery voltage since the last

reset. The voltage shown on the display is averaged each second, and

this allows you to check your charging system (battery charger, charge

controller, etc.,) to ensure the charging voltage has been attained. This

display is also helpful when troubleshooting or detecting if an over-

charge condition has occurred.

To reset this display, press and hold the rotary SELECT knob for 5 seconds

while the Max DC display is shown. After this value has been reset, the

display will begin monitoring and showing new maximum DC input values. If

the battery monitor is not connected or not communicating, the display will

show “0.0”.

1 2 ... 77 78 79 80 81 82 83 84

Commentaires sur ces manuels

Pas de commentaire

Magnum Energy ME-RC Manuel du propriétaire Page 82

Commentaires sur ces manuels