search

Magnum Energy ME-RC Manuel du propriétaire Page 46

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 84
  • Table des matières
  • DEPANNAGE
    •
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 45
39 ©2013 Magnum Energy, Inc.
5.0 Operation
Charger Standby appears on LCD.
PWR (green) LED is on solid and CHG
(green) LED slowly blinks. FAULT
(red) LED is off, and INV (green) LED
could be on or off.
FAULT
PWR
CHG
INV
Charger Standby
Settings/Info..
Figure 5-9, Charger Standby Mode
• Charger Standby – This means the charger has been disabled to
prevent any charging, but the AC power (from shore/utility or generator)
to the AC input is still available on the AC output. This display is shown
when the ON/OFF CHARGER button is pressed while the AC power is passing
through the inverter/charger.
Info: To enable charging again, press the ON/OFF CHARGER button.
When the charger is again enabled, the charger will continue in the
Charge mode it last left and the CHG (green) LED will come on solid.
Charging appears on LCD. PWR
(green) and CHG (green) LEDs are
on solid. FAULT (red) LED is off, and
INV (green) LED could be on or off.
FAULT
PWR
CHG
INV
Charging
Settings/Info..
Figure 5-10, Charging Mode
• Charging – Once Charging mode has been enabled, the unit will wait and
display “Charging” to determine the charge routine. If the DC voltage is low
(≤12.8 VDC/12-volt models, ≤25.6 VDC/24-volt models or ≤51.2 VDC/48-
volt models), the charger will initiate Bulk Charging. If the DC voltage is
high (>12.8 VDC/12-volt models, >25.6/24-volt models or >51.2/48-volt
models), the charger will skip the Bulk and Absorb charging stages and go
directly to Float Charging.
• Bulk Charging – The battery charger is delivering maximum current
(determined by the SETUP menu’s 05 Charge Rate setting) to the batteries.
The charger will remain in Bulk Charge until the absorb voltage (determined
by the SETUP menu’s 04 Battery Type setting) is achieved.
Bulk Charging appears on LCD. PWR
(green) is on solid, and CHG (green)
LED is typically on solid, but may
blink slowly. FAULT (red) LED is off.
INV (green) LED could be on or off.
FAULT
PWR
CHG
INV
Bulk Charging
Settings/Info..
Figure 5-8, Bulk Charging Mode
Vue de la page 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 83 84

Commentaires sur ces manuels

Pas de commentaire
  • Digital Dream RightClick Bell-gossett Algoma-hardwoods Hyundai IT
  • Back to Basics Cafetières Miele Fournitures pour aspirateurs Eaton Alimentations sans interruption (UPS) First Alert Composants des dispositifs de sécurité Citizen Non
  • Canon PowerShot SX600 HS Dyna-Glo RMC-KFA70TDGP Electrolux RAPI2 Electrolux EW7F249S Samsung S22E450DW
  • Smc-networks SMC-EZ6516TX Manuel de l'utilisateur LG FFH-170AX Manuel de l'utilisateur Samsung SNR-3200 Manuel de l'utilisateur Panasonic TXL32D25E Instructions d'exploitation Samsung SGH-C120 Manuel de l'utilisateur