Magnum Energy ME-RC Manuel du propriétaire télécharger pdf (Page 23)

3.0 Setup

Press to save

SETUP

Press

Status...

01 Search Watts

Rotate to

Press to select

Rotate to

desired

selection:

Status...

Search = OFF

...

Status...

Search = 5W

Status...

Search = 10W

Status...

Search = 50W

Figure 3-6, SETUP: 01 Search Watts Selections

Info: When the Search Watts feature is active, “Searching” appears on

the top line of the LCD display and the green INV LED will slowly ﬂ ash.

What is the Search Watts feature? This feature is used to help save

battery power by reducing the inverter’s output to search pulses when there

is no detectable load. If a load greater than the wattage level setting turns

on while the inverter is searching, the inverter will start inverting to provide

full voltage on its output.

Should I use the Search Watts feature? If the inverter can spend a great

deal of time searching (to reduce the power drain on your batteries) and you

can tolerate small loads (<5 watts) being off, then the Search mode feature

should be used. However, if some small loads (i.e., digital clocks, satellite

receivers, answering machines, etc.,) are required to be on, then this feature

should be turned off (Search = OFF).

Where should I set Search Watts? This setting should be adjusted to the

same power level (or the next lower setting) of the smallest load that you plan

to run. If you don’t know the wattage of the smallest load, turn the load on and

decrease the Search Watts setting until the load comes on and stays on.

Info: Even though the Search feature is on, some connected equip-

ment—even if they are off—may draw enough current to keep the

inverter in the Inverting mode (i.e., not “Searching”).

• SETUP: 02 LowBattCutOut – The LBCO setting is used to set the DC

voltage level that turns off the inverter to help protect the batteries from

over-discharge damage. If the battery voltage drops below the LBCO

selected set-point continuously for more than one minute, the FAULT

LED will come on, the inverter will turn off, and the display will show

a Low Battery status. If the battery voltage falls below 8.5 volts (12-

volt models), 17.0 (24-volt models) or 34.0 volts (48-volt models), the

FAULT LED and Low Battery status display will be immediate.

Default settings: LBCO = 10.0 VDC (12v models), 20.0 VDC (24v

models), or 40.0 VDC (48v models)

Range: 9.0-12.2 VDC (12v inverter), 18.0-24.4 VDC (24v inverter), or

36.0-48.8 VDC (48v inverter)

Info: The inverter automatically begins inverting when the DC volt-

age increases to ≥ 12.5 VDC (12-volt models), ≥ 25.0 VDC (24-volt

models), or ≥ 50.0 VDC (48-volt models). If AC power is available

and connected to the inverter’s input, the inverter automatically

clears the low battery fault, passes the input AC power to the output,

and begins charging the batteries.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 83 84

Commentaires sur ces manuels

Pas de commentaire

Magnum Energy ME-RC Manuel du propriétaire Page 23

Commentaires sur ces manuels